The bike will be easier to tune once the head is setup properly.
Took it to Dave at TSP to get the head done. The "Squish".Ī mate had a WR125 which was doing the same thing, fouling plugs, actually, it was killing the plugs dead. I wouldn't even bother trying to tune it until the head has been setup. What would you suggest I order in terms of jets and all that, should I change the slide too? Haha I'm pretty clueless so it's cool to have someone willing to give me a hand. When it ran, the plugs were always black and gummy and it blew a decent amount of smoke. The bike ran good (figured out my coil is stuffed so I gotta fix that) but I wanna order some jets and stuff at the same time so it'll all be ready. So I really have no clue what size jets and needles and stuff I should order. The symbol in front of the 35 (that you think is 61) may well be the square inside a square that mikuni use to id genuine jets.ĭon't worry about asking questions mate.no one is forced to answer them. FYI You should be able to access both these jets through the drain bolt. The pilot jet has a straight cut screwdriver slot and is located directly in front (engine side) of the main jet. The main jet and pilot jet are both in the float chamber. So will that cafe husky thing have the standard float heights and jets and stuff? And I'm in Victoria around Mt Evelyn. Yeah it has the mikuni carb, NGK br9eg plug, the engine seems to run ok, maybe lacking a bit in the power department haha but maybe I'm just getting used to it, but I'm planning and replacing piston and rings and what not soon enough. Haha it's always a pain to help out the kid with barely any idea of what's goin on. You'll soon feel what changes are right and which ones are not.īe aware, particularly with these bikes, that each engine will require slightly different setting. Take your time, make small changes and only change one thing at a time, test riding between after each one. Jetting is a skill you learn by trial and error. Which does yours have?įirst thing to do is remove the carb and find out what jets your running. The original carb was a Mikuni TMX, but a common swap was to fit a Keihin PWK or Lectron. How does the engine run? What spark plug are you using - brand and designation?
There's a lot of information on the wr125 on site "cafe husky", particularly regarding carby tuning. Welcome to the world of husky ownership mate.Īlways remember you don't own a Husqvarna, you understand it.
0 kommentar(er)
